BEP Dual Bank Control Battery Switch


BEP Dual Bank Control Battery Switch

Product no.: 772-DBC-EZ

In stock can ship within 3 days

Was NZ$135.00
NZ$121.60
You save NZ$13.40


Possible delivery methods: $4.99 Nation Wide Shipping SMALL ITEMS UP TO 10KG, Pickup From Shop Avondale Auckland NZ, $35.00 Bulk Large Ropes, Chains and Goods 10-25kg, $70.00 Bulk Shipping Stoves & Fridges + Goods over 30kg, Free Shipping NZ Wide For Fishing & Cast Nets Only, $3.99 Shipping for Tasmanian Devil Lures ONLY (Kilwell Promotion)

BEP Dual Bank Control Battery Switch

Features: 

Innovative Dual Bank Control switch is like 3 switches in one – House, Start, and Emergency Parallel.

Offering easy intuitive control for the boater, the Dual Bank Control switch features a unique isolated-On position which allows use of house loads and VHF radio if the engine needs to be electrically isolated, or allows the engine to be isolated during servicing while still providing power to house loads (for lighting, stereo, fridge etc). For boats or vehicles with single Engine and House battery bank, Dual Bank Control allows the use of optimized battery banks for their respective loads; an appropriately sized deep cycle bank for House loads, and thin plate starting batteries for the Engine. Further, sensitive electronics are isolated from starter motor induced voltage spikes because House and Engine loads are separated during normal operation, unlike Selector battery switches. As easy as 1, 2, 3, these revolutionary EZ Mount battery switches allow you to wire from the front for the easiest surface mounting. With their shared interconnection height, EZ-Mount battery switches "cluster" directly with the Pro Installer Busbar Range, resulting in the fastest, most compact installations. Optimized cable access makes installation a breeze.

  • Tested to UL1107 ignition protection, CE
  • Tinned copper 10mm (3/8 inch) studs
  • Stainless steel washers and nuts
  • Fibre reinforced plastics
  • 400A Continuous / 600A 5 minutes Intermittent / 1500A 10 seconds Cranking (cable size to achieve ratings 120mm², 4/0, smaller cable size will reduce the Amp rating)
  • Waterproof to IP67
  • Same interconnection height as Pro Installer
  • Removable knob allows isolation during servicing
  • 3 removable side plates for protection

For surface mounting only

4x M10 (3/8 inch) Connection Studs

Module dimensions LxWxH: 98 x 98 x 93mm

NZ Code: 772-DBC-EZ

OBT 10:29 pm PST 6/10/2018

We also recommend


Browse this category: Battery Switches